Description:

100% brand new

High quality 10

Ml's UV green paint.

Keep printed circuit boards free from short circuits and arcs.

This paint is used to protect PCB traces from corrosion and moisture. It can also be used for PCB repair after soldering and rework.

 

Specification:

Welding oil: green/blue/yellow/red/black

Syringe length: approx. 10 cm

Material: Coating

Capacity: 10ml

Lights: 9 LEDs

Quality: brand new

Voltage: about 4.5V

Power Supply: 3 AAA batteries (not included)

Application: LOCA UV Adhesives for Mobile Phone Repair

Weight: 40g

Size: 87mm * 26mm

Quality: brand new

 395nm UV light

Usage:

Apply a VERY thin layer of paint - A small amount spreads far- Do not over apply  

To Cure , exposure to ultraviolet light (or sunlight) for a few minutes.

Tip - A warm PCB ( 120 C ) helps with the curing . Best results are achieved with a combination of Simultaneous hot air ( 300C for a few seconds ) and UV light 

Wash off excess paint with a Q-tip and alcohol 

 * Note that if you are using a 395nm UV light to cure , you must apply a VERY THIN layer of mask , and then cure . A 395nm UV light will not cure a thicker layer properly